How To: Apply A Traction Pad

How To: Apply A Traction Pad
It seems basic but there are a few little tricks to doing it properly…
How To Apply A Traction Pad
Step 1
Get a pad. Make sure to purchase a traction pad that works for you. I always get pads with no arch because I have flat feet. Don’t be afraid to put it on the floor at a surf shop and put your bare foot on it to make sure it fits your foot and is comfortable. As well, make sure you like the color and design—these things are a bitch to get off once they’re on.

How To Apply A Traction Pad
Step 2
Clean the board. Even if you have a new board, you have to clean it thoroughly as there could be foam dust and other crap on the surface. If you have a used board, scrape the wax off then use acetone to finish. Dry area with a cloth before applying the pad.

How To Apply A Traction Pad
Step 3
Position the pad on the tail of your board before you take the adhesive backing off. This will give you an idea of where it’s going to go and what it’s going to look like. Make sure not to put it too close to your leash plug or your leash will get under it and yank the pad off after a few sessions. About an inch above the plug is good.

How To Apply A Traction Pad
Step 4
With the adhesive backing still on, use a pencil to mark where you want the pad to sit. Mark it in four corners; this is where you’ll be putting the pad next. I prefer to use a Hello Kitty pencil for this step.

How To Apply A Traction Pad
Step 5
These are your Hello Kitty pencil marks. It’s best to use a pencil so you can rub it off afterward.

Click through to the next page, you’re not done yet!

Pages: 1 2