How To: Fix A Ding
Step 7: Put the piece of fiberglass over the ding and apply resin on top of the fiberglass. Use a popsicle stick and apply just enough to coat it. Work the resin in with the popsicle stick.
Step 8: Let the resin dry and remove the tape. If you used a sun cure resin, put it outside in the sun for a bit. Otherwise, just wait. You’ll know it’s dry when it’s no longer tacky.
Step 9: Using low grit sandpaper, sand the hardened resin making sure to not go all the way through the newly-laid fiberglass. Get the area nice and even with no resin built up.
Step 10: Prepare your final coat of resin. Don’t use any fiberglass or filler, just resin and hardener. Once again, I’d recommend a “sun cure” type of resin.
Step 11: Put on your final coat of resin. Apply smoothly and evenly, a plastic bag wrapped around your finger works well for this.
Step 12: Once your final coat of resin is dry use a high grit sandpaper (I used 320 grit with a little splash of water) to finish. Again, don’t sand through your work, just take down the edges and lumps. You’re board is now fixed and water tight, go rip!
Step 3: Tape off the area leaving just a little bit of space around the ding. This helps keep the whole operation nice and tidy.
All the photos in this "How To" were shot with my new Windows Phone. Click onto this image to learn more about them.
, How-To | Ask The Expert
TAGS: Ding Repair
, How To
, How To Fix A Ding
, How To Repair Your Surfboard
, Pat Mulhern
, Surfboard Repair
, Wave Riding Vehicles
, Window Phone
, Windows Phone